Sorry if this has been asked before, but I have a puzzling problem with an
isosurface I am using. When I trace the scene I get a warning that the
max_gradient is about 8+ and I need to increase it or I'll get holes. So I
do, and trace again, but then I get a message saying max_gradient is 7.1
and I should reduce it to make it trace faster. This happens even though I
haven't changed anything except the max_gradient value. I can chase the
max_gradient value around indefinitely but no matter what I do it always
gives me either the 'too big' or 'too small' message and keeps changing.
Why does this happen and is there anything I can do to correct it?
L
-
Post a reply to this message
|